Project

General

Profile

Activity

From 04/12/2012 to 05/11/2012

05/09/2012

04:22 PM Software Development: RE: Starterware EMIFA to FPGA example code
Hi Mike,
In the case of 32 bit transfers as described above -
Can you tell me which 16-bit value is transferred ...
Emmett Bradford

05/08/2012

04:55 PM FPGA Development: RE: Programming the FPGA
Appreciate the feedback on the wiki page. I've updated it per your comments.
-Mike
Michael Williamson
04:40 PM FPGA Development: RE: Programming the FPGA
Thanks! That worked. An even better solution than the bootfpga solution.
I was basing what I did on the wiki pag...
Tim Eastham
03:03 PM FPGA Development: RE: Programming the FPGA
Hi Tim / Emmett,
Did you remember to saveenv? (just checking)
A couple of things:
You might want to avoid u...
Michael Williamson
02:15 PM FPGA Development: RE: Programming the FPGA
Emmett and I were able to get the DONE LED by calling loadfpga after the loadb 0xc0700000. The problem is that when ... Tim Eastham
02:01 PM FPGA Development: Programming the FPGA
I have read both forum entries of the same name.
The first one seems to be most applicable, since I have the MityARM...
Emmett Bradford

05/02/2012

07:46 AM Software Development: RE: uPP/DMA registers
We have demonstrated capturing as high as 100 MB/sec using UPP in 180 MB blocks without issue. So it's feasible. If... Michael Williamson
03:10 AM Software Development: RE: uPP/DMA registers
@Mike
Thanks for the detailed answer. We are only using the AM1808 as an embedded video server for the stream comi...
Shahzad Malik

04/30/2012

10:12 AM Software Development: RE: uPP/DMA registers
Shahzad, I have not found uPP drivers for the ARM in linux. My suggestion in developing them is to read the TI uPP ... Scott Whitney

04/29/2012

06:25 PM Software Development: RE: TI C6EZAccel library with MityDSP Platform - OmapL138
Hi Michele,
If you would like to use the full TI DVSDK (including C6EZAccel), you can install it from TI (along wi...
Michael Williamson
06:05 PM Software Development: TI C6EZAccel library with MityDSP Platform - OmapL138
Dear Sirs,
does anybody there managed to install and use the C6EZAccel library for the OMAPL138 processor, using the...
Michele Canepa

04/28/2012

10:19 AM Software Development: RE: uPP/DMA registers
If you are not using the on-Board NAND in your design (e.g., booting to a RAMDISK or off of MMC or something), then t... Michael Williamson
09:52 AM Software Development: RE: uPP/DMA registers
Hi Mike,
Thanks for the prompt reply. Actually the data stream is from an H.264 encoder in an FPGA, so im not sure...
Shahzad Malik
08:18 AM Software Development: RE: uPP/DMA registers
Hello Shahzad,
Unfortunately, there is still no UPP driver available. Have you looked at pushing the data in usin...
Michael Williamson
04:11 AM Software Development: RE: uPP/DMA registers
Hi Mike,
I am looking for a uPP driver for linux and I was searching around when I came across this thread. I know...
Shahzad Malik

04/26/2012

12:21 AM Software Development: RE: FS Corruption due to dropping power
Hi Mike,
Thanks for the reply. This is reasuring that it is a FS corruption problem. I have instigated a read onl...
Keith Fletcher

04/25/2012

12:57 PM Software Development: RE: Starterware EMIFA to FPGA example code
Hi Emmett,
Are you using linux or starterware? On starterware, if you are launching from u-Boot (which configures...
Michael Williamson
12:37 PM Software Development: Starterware EMIFA to FPGA example code
Hello,
I have used your "EMIFA_iface" VHDL example to make a simple FPGA to test by reading/writing to registers r...
Emmett Bradford

04/13/2012

06:31 PM PCB Development: RE: RTC Battery Drain
Hi,
Wanted to follow up on this. We have seen RTC battery drainage, but at the time we looked at it we were using...
Michael Williamson
06:28 PM Software Development: RE: FS Corruption due to dropping power
Hi Keith,
I have seen these symptoms before, and I'm pretty sure it's filesystem corruption related (I suspect ude...
Michael Williamson

04/12/2012

04:29 PM Software Development: FS Corruption due to dropping power
Hi, We are developing a system where the user is unlikely to power down gracefully, even if asked to do so and ultima... Keith Fletcher
 

Also available in: Atom

Go to top
Add picture from clipboard (Maximum size: 1 GB)