Project

General

Profile

Activity

From 02/27/2015 to 03/28/2015

03/26/2015

11:21 AM Software Development: RE: Pull-up Enable for MityDSP L138 (cp[0])
To be more specific, @CP[0]@ covers the following pins: @GP0[8] (OMAP_GP0_8), GP0[9] (OMAP_GP0_9), AHCLKX (AUDIO_SYS... Jonathan Cormier

03/25/2015

10:57 AM FPGA Development: RE: Mity L138F FPGA -> OMAP interrupt lines
Hi Alex,
I was using MDK_2012-03-12 and in the included UCF the IO standard on those pin was different:
NET "o_...
Christopher Brunson
10:55 AM Software Development: Pull-up Enable for MityDSP L138 (cp[0])
I'm trying to get a new hardware design up and running with the MityDSP L138, using the Industrial IO board as a star... Ronald Kabler

03/23/2015

05:08 PM FPGA Development: RE: Mity L138F FPGA -> OMAP interrupt lines
Chris,
Hopefully you happened upon this on your own but the details for the pin-configuration, voltage standards, ...
Alexander Block

03/12/2015

11:06 AM FPGA Development: RE: FPGA serial programming interface
We are happy to provide further assistance with this issue, however I will be contacting you directly at your e-mail ... Alexander Block

03/11/2015

10:23 AM FPGA Development: RE: FPGA serial programming interface
Thanks for the information.
We are prototyping a future product and due to pin count restrictions we can't use par...
stephan berner
10:18 AM FPGA Development: RE: FPGA serial programming interface
I discussed this with one of our engineers here and it may be possible however they is likely a bit of work required ... Alexander Block
08:32 AM FPGA Development: RE: FPGA serial programming interface
SB,
I apologize.
The M0 and M1 FPGA pins are tied to resistors on the module to GND (M0) and 3.3V (M1) forcing...
Alexander Block

03/10/2015

05:04 PM FPGA Development: RE: FPGA serial programming interface
I understand that. However, I would like to configure the FPGA in serial slave mode. stephan berner
05:01 PM FPGA Development: RE: FPGA serial programming interface
SB,
The FPGA is configured using 8 bit parallel slave select mode via the EMIFA bus connection to the Omap L138 pr...
Alexander Block
03:36 PM FPGA Development: FPGA serial programming interface
hi,
are the pins CCLK, DIN and the MODE pins available on the OMAP-138 as GPIOs, or are they open/hardcoded on the...
stephan berner

03/05/2015

05:20 PM Software Development: RE: Write to SharedMem from DSP and read it from ARM
Thanks for the cache info. Completely missed that part.
I reverted to the original code, and I've added BCACHE_wb(...
Frank C
 

Also available in: Atom

Go to top
Add picture from clipboard (Maximum size: 1 GB)