Mity CPU Platforms » MityDSP-L138 (ARM9 Based Platforms)

03/12/2018

05:46 PM Software Development: RE: Linux Boot Parameter and NAND Partition

Okan Çalış wrote:
> I know I can do that. _(You suggested doing so when we realized, the kernel on the custom board ... Jonathan Cormier

01:31 PM Software Development: RE: Linux Boot Parameter and NAND Partition

Also, when I issue a "@cat /proc/mtd@" with NFS, it prints only the SPI partitions starting from @mtd0@; it doesn't p... Okan Çalış

08:16 AM Software Development: RE: Linux Boot Parameter and NAND Partition

I know I can do that. _(You suggested doing so when we realized, the kernel on the custom board listed the MTD partit... Okan Çalış

03/09/2018

02:00 PM Software Development: RE: Linux Boot Parameter and NAND Partition

You can manually update the nand partition tables by changing the file arch/arm/mach-davinci/board-mityomapl138.c and... Jonathan Cormier

05:20 AM Software Development: RE: Linux Boot Parameter and NAND Partition

> Where did you print out this partition table?
From the @mtdparts@ command of the U-Boot. It is also consistent w... Okan Çalış

03/08/2018

02:41 PM Software Development: RE: Linux Boot Parameter and NAND Partition

Okan Çalış wrote:
> Hi,
>
> I have a general question about Linux on MityDsp, which might help me solve "the prob... Jonathan Cormier

12:49 PM Software Development: Linux Boot Parameter and NAND Partition

Hi,
I have a general question about Linux on MityDsp, which might help me solve "the problem I consulted you about... Okan Çalış

02/22/2018

03:12 PM Software Development: RE: Kernel panics on custom board: "No init found. Try passing init= option to kernel"

Okan Çalış wrote:
> Hi Jonathan, thanks for your reply.
>
> > The kernel and u-boot both have to use the same ECC... Jonathan Cormier

12:07 PM Software Development: RE: Kernel panics on custom board: "No init found. Try passing init= option to kernel"

Hi Jonathan, thanks for your reply.
> The kernel and u-boot both have to use the same ECC strength.
I'm afraid ... Okan Çalış

02/21/2018

02:14 PM Software Development: RE: Kernel panics on custom board: "No init found. Try passing init= option to kernel"

Okan Çalış wrote:
> Hi,
>
> I couldn't reply sooner because I've been handling some other kernel-related problems... Jonathan Cormier

07:38 AM Software Development: RE: Kernel panics on custom board: "No init found. Try passing init= option to kernel"

Hi,
I couldn't reply sooner because I've been handling some other kernel-related problems by using NFS as a tempor... Okan Çalış

02/13/2018

02:04 AM PCB Development: getting AUDIO_SYSCLK to expansion connector

I have an Industrial I/O board and need to get the AUDIO_SYSCLK signal out to an expansion board connector. Currently... Tom Riddle