Project

General

Profile

Activity

From 02/13/2018 to 03/14/2018

03/12/2018

05:46 PM Software Development: RE: Linux Boot Parameter and NAND Partition
Okan Çalış wrote:
> I know I can do that. _(You suggested doing so when we realized, the kernel on the custom board ...
Jonathan Cormier
01:31 PM Software Development: RE: Linux Boot Parameter and NAND Partition
Also, when I issue a "@cat /proc/mtd@" with NFS, it prints only the SPI partitions starting from @mtd0@; it doesn't p... Okan Çalış
08:16 AM Software Development: RE: Linux Boot Parameter and NAND Partition
I know I can do that. _(You suggested doing so when we realized, the kernel on the custom board listed the MTD partit... Okan Çalış

03/09/2018

02:00 PM Software Development: RE: Linux Boot Parameter and NAND Partition
You can manually update the nand partition tables by changing the file arch/arm/mach-davinci/board-mityomapl138.c and... Jonathan Cormier
05:20 AM Software Development: RE: Linux Boot Parameter and NAND Partition
> Where did you print out this partition table?
From the @mtdparts@ command of the U-Boot. It is also consistent w...
Okan Çalış

03/08/2018

02:41 PM Software Development: RE: Linux Boot Parameter and NAND Partition
Okan Çalış wrote:
> Hi,
>
> I have a general question about Linux on MityDsp, which might help me solve "the prob...
Jonathan Cormier
12:49 PM Software Development: Linux Boot Parameter and NAND Partition
Hi,
I have a general question about Linux on MityDsp, which might help me solve "the problem I consulted you about...
Okan Çalış

02/22/2018

03:12 PM Software Development: RE: Kernel panics on custom board: "No init found. Try passing init= option to kernel"
Okan Çalış wrote:
> Hi Jonathan, thanks for your reply.
>
> > The kernel and u-boot both have to use the same ECC...
Jonathan Cormier
12:07 PM Software Development: RE: Kernel panics on custom board: "No init found. Try passing init= option to kernel"
Hi Jonathan, thanks for your reply.
> The kernel and u-boot both have to use the same ECC strength.
I'm afraid ...
Okan Çalış

02/21/2018

02:14 PM Software Development: RE: Kernel panics on custom board: "No init found. Try passing init= option to kernel"
Okan Çalış wrote:
> Hi,
>
> I couldn't reply sooner because I've been handling some other kernel-related problems...
Jonathan Cormier
07:38 AM Software Development: RE: Kernel panics on custom board: "No init found. Try passing init= option to kernel"
Hi,
I couldn't reply sooner because I've been handling some other kernel-related problems by using NFS as a tempor...
Okan Çalış

02/13/2018

02:04 AM PCB Development: getting AUDIO_SYSCLK to expansion connector
I have an Industrial I/O board and need to get the AUDIO_SYSCLK signal out to an expansion board connector. Currently... Tom Riddle
 

Also available in: Atom

Go to top
Add picture from clipboard (Maximum size: 1 GB)