Project

General

Profile

about boot

Added by shengyou gao over 12 years ago

I wonder how the boot mode switch from SPI1 to UART1 using EXT_BOOT# signal? Thank very much.


Replies (2)

RE: about boot - Added by Michael Williamson over 12 years ago

The EXT_BOOT# signal drives a small mux circuit on the SOM that changes the boot strap pull-up/pull-down options on the OMAP-L138 such that it will use UART0 instead of SPI1_CS0 as the primary boot device. If you need details about this, check the data sheets on the OMAP-L138 or the AM1808 regarding the boot modes.

Hope this helps.

-Mike

RE: about boot - Added by shengyou gao over 12 years ago

Mike,
Thank you very much. I understand.

    (1-2/2)
    Go to top
    Add picture from clipboard (Maximum size: 1 GB)