Mity CPU Platforms » MityDSP-L138 (ARM9 Based Platforms)

03/04/2012

06:11 PM Software Development: RE: about boot

Mike,
Thank you very much. I understand. shengyou gao

04:51 PM Software Development: RE: about boot

The EXT_BOOT# signal drives a small mux circuit on the SOM that changes the boot strap pull-up/pull-down options on t... Michael Williamson

04:56 PM PCB Development: RE: FPGA no-connects for 45 size FPGA on MityDSP-L138F

The bare board PCB for the two variants of the SOM are identical, the only difference is the BOM used for assembly. ... Michael Williamson

03/01/2012

08:28 AM Software Development: about boot

I wonder how the boot mode switch from SPI1 to UART1 using EXT_BOOT# signal? Thank very much. shengyou gao

02/28/2012

08:47 AM PCB Development: FPGA no-connects for 45 size FPGA on MityDSP-L138F

(Posted on behalf of a customer)
We have done a design using the MityDSP-L138F SOM. I tried avoiding using the pin... Thomas Catalino

02/22/2012

05:01 PM Software Development: RE: Hello World Starter Guide Permission Issue

You rock! It was the file that was the problem. I found the executable and it worked. Thanks! Tim Eastham

04:50 PM Software Development: RE: Hello World Starter Guide Permission Issue

Hi Tim,
First, the reason you're getting the "-sh: ./hello.o: Permission denied" error is because the file you are... Gregory Gluszek

04:25 PM Software Development: Hello World Starter Guide Permission Issue

I am a newbie to the arm environment and quite green on linux as well. I have been going through the hello world exa... Tim Eastham

02/16/2012

08:03 PM PCB Development: MityDSP-L138F Footprint Question

(posted on behalf of a customer)
For the MityDSP-l138F, I noticed the drill hole for the standoff in the Altium f... Thomas Catalino

02/06/2012

08:17 PM FPGA Development: AXI Compatibility?

(posted on behalf of a customer for the MityARM-1808F module)
Any advice on how to connect your EMIF interface to... Thomas Catalino