Project

General

Profile

BUSY and AWAKE LEDs

Added by Stewart Cobb about 11 years ago

On my L138-DI-225-RI board, I observe two LEDs labeled "BUSY" and "AWAKE". These are located next to the "DONE" LED which is obviously connected to the DONE pin of the FPGA. Are the other two LEDs connected to the FPGA? If so, what pins are they connected to? My project could really use a blinking light to let the operators know it's alive.


Replies (1)

RE: BUSY and AWAKE LEDs - Added by Michael Williamson about 11 years ago

D2 (AWAKE) is connected to pin P15 of the FPGA. Drive high to light.
D3 (BUSY) is connected to pin P16 of the FPGA. Drive high to light.

-Mike

    (1-1/1)
    Go to top
    Add picture from clipboard (Maximum size: 1 GB)